Have you broken the sheet on the mdf door?

Use of MDF doors influenced – Problems that can occur during operation.

Infoltered MDF fronts are increasingly used in our country. Abroad it has been used for many years as a practical and versatile solution.

Fortunately, we have two specialized local producers who give a fairly good service. Especially one of them.

Yet the problems can occur over time, in use.

The technological process is not as simple as it seems and not exactly like other operations in the furniture sector.

It matters the quality of the sheet, its thickness, the quality of the MDF support. Then the sticker, the gluing temperature, the working conditions.

The percentage of «bugs» is lower than electronics. Few in number are problematic situations but they are embarrassing.

Where can problems arise?

First of all on the upper fronts, left left left, at the bottom. Either the customer has too small a hood (here it is advisable to use hoods wider than 60 cm) or very often it doesn’t start! The high pot on the fire releases the boiling steam which has about 30-40 cm to the body that reaches a temperature comparable to the one to which the bond has been made.

In this situation there are high possibilities that the sheet is collected, «created» or after repeated situations to detach itself.

The same thing can happen in the vicinity of a stove that does not close well or is scarcely ventilated.

Some of the manufacturers adopt measures from design and execution so that there are no problems. Others seem to influence the design designed by them and risks.

The measures are simple and can remind them at any time our sales consultants.

However, it happens that after longer periods of time the sheet will be detached, especially to the shiny fronts. It is known that the shiny sheet is glued is made with a small adhesive that is sprayed in the edge of the edge. The adhesive in large quantities would give the effect of orange peel.

Imagine that professionals what happens if the spray nozzle is a bit clogged? If not adhesive enough, does it become?

In addition, as professionals we know that these things are possible, everyone makes efforts to minimize them.

In these situations the solution is to replace the front or fronts if the discoloring has occurred.

The situations of this type are rare but appear in a proportion of 0.5 per thousand.

You must know that technology has its limits. You will not get a lucid front extended to the standards of a painting. Since you could access the profiles profiles covered by lamina that seem almost identical to the wooden fronts. Now there are structured sheets that imitate the deep veneer.

Any front like any surface of the furniture must be maintained in a certain way. And the stone stone is stained as the song on the door can be detached from the heat.

It is important that problems can be solved clearly, efficiently and in defined terms so that no one is dissatisfied.